CURRENT LOCATION:HOME > NEWS > Industry News >
  • Solution for the problem of feeder assignment

    If you optimize an optimized program again, it changes the current feeder assignment. Or even though you try to change the current feeder assignment by the Optimization function, it does not change the feeder assignment. Cause: The Pick Data field is not   [Read More]
    Mar 15, 2022

  • Why you cannot refer to the database?

    Why you cannot refer to the database? Because the database file is not set correctly on the Environmental setting screen of the Program Editor Utility. Solution: Set the database file correctly on the Enviromental setting screen invoked from the File menu  [Read More]
    Mar 15, 2022

  • How to solve the <Start>/<Stop> switches cannot function?

    Symptom: The START/STOP Switches cannot function. Cause: When the cover on the side opposite to these switches is opened, they are disabled for safety. Corrective action: Close the cover located on the opposite side.  [Read More]
    Mar 15, 2022

  • How to deal with SMT's poor tin plating?

    Wave crest: the surface of a wave is covered by a layer of oxide that remains almost stationary along the length of the solder wave, In the process of wave soldering, PCB contact to the front surface of tin wave, oxide breakdown, tin wave in front of   [Read More]
    Jan 04, 2022

  • vacuum value without nozzle

    This menu command allows you to set vacuum value of each head on which no nozzle is mounted. This setting causes the system to check a deviation of the cacuum values of heads. If the value changes greatly by comparing with the value set at delivery of the  [Read More]
    Jan 03, 2022

  • 8 steps need to set a nozzle?

    Setting items 1) Noz. No. ( Nozzle No. ) Set the nozzle number to be assigned to the ATC. 2) Type ( Nozzle Type ) Set the type of a nozzle to be assigned to the ATC. Available nozzle types: a; normal ( Normal Nozzle) b; T-type ( Cleaner type nozzle) c  [Read More]
    Jan 03, 2022

  • How to set a nozzle?

    How to set a nozzle? The reference head on which a nozzle is mounted measures the height of the nozzle tip (measured value is to be entered into the Noz. height field) and nozzle width ( to be entered into the Noz. No. ) with laser. In addition, the refer  [Read More]
    Jan 03, 2022

  • ATC Nozzle Setup

    Setting Group When you select the setting group command from the menu bar, the following items appear on the displayed menu. ATC nozzle setup This menu command allows you to set information on each nozzle mounted on the ATC. When you select this ATC n  [Read More]
    Jan 01, 2022

  • How to register customized nozzle data into mounter?

    Registered nzl. no table This command displays the list of the nozzles already registered and their information on the screen. When you select the Registered nzl. no table command from the filemenu, the Registered nozzle no. table dialog box appears o  [Read More]
    Jan 01, 2022

|<12345678>| Page 4 of 8